1. Find Your Solid Wallet Address
Your Solid account includes a built-in Safe Smart Wallet, with a single address used for deposits across supported networks.
Steps
Open the Solid app (web or desktop)
Click your profile icon (top-right)
Select Settings
Click Account details
Copy your Wallet Address (starts with
0x…)
This is the address you’ll use to deposit from Fuse or Ethereum.
2. Deposit Assets from the Fuse Network
Supported Fuse assets
FUSE
USDC/USDT (Fuse & Ethereum)
Supported wallets
MetaMask
Rabby
Fuse Wallet
Any wallet connected to the Fuse RPC
Steps
Open your wallet
Switch network to Fuse
Click Send / Transfer
Paste your Solid Wallet Address
Select the asset (e.g. FUSE or USDC)
Enter the amount
Confirm the transaction
Once confirmed on-chain, Solid automatically detects the deposit.
3. Deposit soUSD from Ethereum (EOA Wallet)
Solid also supports soUSD deposits from Ethereum, sent directly from your EOA wallet (e.g. MetaMask).
Important
The same Solid Wallet Address is used
The network must be Ethereum
The asset must be soUSD
Steps
Open your wallet (e.g. MetaMask)
Switch network to Ethereum
Click Send
Paste your Solid Wallet Address
Select soUSD
Enter the amount
Confirm the transaction
After confirmation, the soUSD will appear in your Solid account and can be withdrawn or managed from the app.
4. Where Your Deposit Will Appear
After a successful deposit:
USDC/USDT (Fuse & Ethereum) appears in your Wallet balance
soUSD (Ethereum) appears in your assets with a Ready to withdraw status
FUSE appears under Your assets
Fuse deposits typically appear within seconds to a few minutes.
Ethereum deposits may take slightly longer depending on network congestion.
5. Important Notes
Minimum deposit
Deposits must be at least $10 for gasless processing
Deposits below $10 may not be covered by Solid’s gas sponsorship
Free on-ramp & off-ramp
Solid covers blockchain fees for eligible deposits
Solid does not charge deposit fees
KYC requirements
Crypto deposits (Fuse & Ethereum) → No KYC required
Bank deposits → KYC required
Disconnecting a wallet
If you connected an external wallet during deposit, you can disconnect it anytime by clicking Disconnect in the deposit flow.
6. Troubleshooting
If your deposit isn’t showing:
Confirm you sent funds to the correct Solid Wallet Address
Verify the network:
Fuse assets → Fuse network
soUSD → Ethereum network
Wait a few minutes for indexing
Check the transaction on:
Fusescan (Fuse deposits)
Etherscan (Ethereum deposits)
If the transaction is confirmed but still not visible after 10 minutes, contact Support via the in-app chat.